Cervis TM70 Manual de Instalação

TM70 PUSH BUTTON V11.doc (01/07) IKUSI reserves the right to modify this information without prior notification. OP

TM70 PUSH BUTTON V11.doc (01/07) 8 On receiving a signal from the transmitter, the following LED’s will light up on th

TM70 PUSH BUTTON V11.doc (01/07) 9 5.- USING THE SET To ensure correct use of the equipment, follow the instructions below:  Make

TM70 PUSH BUTTON V11.doc (01/07) 10 6.- MAINTENANCE 6.1.- WARRANTY IKUSI guarantees the TM70 remote control sets for a period of

TM70 PUSH BUTTON V11.doc (01/07) 11 6.3.- FAULT FINDING The transmitter and receiver both have status monitoring LED’s, which help

TM70 PUSH BUTTON V11.doc (01/07) 12 If the problem is associated with the equipment, please send both the transmitter and the recei

TM70 PUSH BUTTON V11.doc (01/07) 13 ANNEX A - PROGRAMMING A SPARE TRANSMITTER. In case of damage to the transmitter, it

TM70 PUSH BUTTON V11.doc (01/07) 14 ANNEX B.- PROGRAMMING THE MACHINE IDENTIFICATION IN LCD TRANSMITTERS. Transmitters with the

TM70 PUSH BUTTON V11.doc (01/07) i I N DEX PAGE. 1.- DECLARATION OF CONFORMITY ...

TM70 PUSH BUTTON V11.doc (01/07) 1 1.- DECLARATION OF CONFORMITY DECLARACION DE CONFORMIDAD DECLARATION OF CONFORMITY KONFORMITÄTSE

TM70 PUSH BUTTON V11.doc (01/07) 2 2.- SYSTEM DESCRIPTION The TM70/1 and TM70/2 push-button transmitter type, radio remote

TM70 PUSH BUTTON V11.doc (01/07) 3 3.- SAFETY INSTRUCTIONS These instructions must be read carefully in order to install and use th

TM70 PUSH BUTTON V11.doc (01/07) 4 4.- INSTALLATION 4.1.- THE CB60 BATTERY CHARGER The battery charger CB60 has two chargin

TM70 PUSH BUTTON V11.doc (01/07) 5 4.2.- RECEIVER Make sure that the crane is stopped for the entire duration of the

TM70 PUSH BUTTON V11.doc (01/07) 6 Connect the power supply and the receiver outputs on the corresponding relay board plug-in termin

TM70 PUSH BUTTON V11.doc (01/07) 7 4.3.- STARTING UP Proceed with caution; the equipment may not be connected correctly which may