Cervis TM70 Manual de Instalação descarregar pdf (Página 10)

TM70 PUSH BUTTON V11.doc (01/07) 8

On receiving a signal from the transmitter, the following LED’s will light up on the

receiver:

POWER: ON, indicates that the power supply is correct.

HARDOK: ON, indicates that defects have not been detected on the board.

SIGNAL: ON, indicates that it is receiving a RF signal at the working frequency.

DATA: When ON indicates that the data received has a correct format.

ID: When ON indicates that the receiver has recognised the transmitter’s

identification code..

Now, the STOP relays K15 and K16 relays will be activated. The K2/START relay is

activated once the start button is pushed.

Press on any of the transmitter’s manoeuvre buttons and its corresponding relay will be

activated. In case of an active manoeuvre, the safety relay K1/SAFETY will also

activate.

Check to make sure all the other manoeuvres work in this way.

Turn off the transmitter using the STOP button, and make sure that on doing so the

relays are deactivated and the DATA, ID and SIGNAL LED’s go out. They behave

exactly as in ‘SCANNING’ mode.

Reconnect the power supply to the motors, move to the usual work position and check

to see if all the manoeuvres and the stop button are functioning correctly.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Sem comentários

Cervis TM70 Manual de Instalação Página 10