Cervis TM70 Manual de Instalação descarregar pdf (Página 12)

TM70Bi V3.1 (03/09) 1121174.pdf

IKUSI reserves the right to change this information without prior notice.

5.3 - STARTING

Proceed with caution; the equipment may not be connected correctly which may lead

to unforeseeable movements on starting-up.

Once the receiver has been connected, disconnect the power supply to the motors, (for example,

by removing the fuses) and power on the receiver. First of all the LEDs will light on an instant to

test that all are all right, after this the receiver will enter into a ‘SCANNING’ mode and the following

LED’s will be lit in the receiver;

POWER (1): ON, indicates that the power supply is correct.

HARDOK (2): ON, indicates the absence of faults on the boards.

SIGNAL (3): OFF, in the case of the channels being signal free. Blinks ON when

there is a RF signal on the channels.

DATA (4): OFF, when there is not another TM70 system active in the area. Blinks

ON in the opposite

case.

ID (5): OFF

CAN_RUN (6): ON, Indicates that CAN communications with expansion boards are

OK.

CAN_ERR (7): OFF

ORDER (8): OFF

RELAY (9): OFF

Figure 5. Signalling LEDs in the

receiver.

1.- Label for crane identification.

Optional: LCD

Display.

2.- LED.

3.- Manoeuvre button.

4.- Contact key.

5.- Start button.

6.- STOP button.

7.- Option: Range Limitation.

Figure 6. Command and signalling elements in the

transmitter

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Sem comentários

Cervis TM70 Manual de Instalação Página 12