Cervis TM70 Manual de Instalação descarregar pdf (Página 71)

TM70Bi V3.1 (03/09) 1121174.pdf

IKUSI reserves the right to change this information without prior notice.

OUTPUT 1 (VO1)

The connections of the output 1 are through 4 pole terminal plug, with the follow pin assignment:

Output 1 connector

Pin Name

Function

VPP1

Power of channel 1

GND1

Ground of channel 1

VO1

Analogue output of channel 1

VR1

Zero position signal signal to get through the output 1 when the relay is inactive

OUTPUT 2 (VO2)

The connections of the output 1 are through 4 pole terminal plug, with the follow pin assignment:

Output 2 connector

Pin name

Function

VPP2

Power of channel 2

GND2

Ground of channel 2

VO2

Analogue output of channel 2

VR2

Zero position signal signal to get through the output 2 when the relay is inactive

ISP (PROGRAMACION “IN CIRCUIT” / “IN SYSTEM”)

The expansion has a connector to record “In-System” (eg. Microprocessor software update). This connector

has 10 pins:

ISP connector

Pin name

Function

ISP2

Input connected to the ground to place the microcontroller in recording mode

TX2

Not used

RX2

Receiving data signal

GND

Ground

RX1

Receiving data signal

TX1

Transmisión data signal

ISP

Not used

VCC

Power supply output at 3,3 V

MRNOT

Reset input, active when it is connected to ground

+VI

Power supply output at 12 V (not stabilized, can vary between 8 y 22 V)

1 2 ... 66 67 68 69 70 71 72 73 74 75 76

Comentários a estes Manuais

Sem comentários

Cervis TM70 Manual de Instalação Página 71

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Cervis TM70