Cervis TM70 Manual de Instalação descarregar pdf (Página 13)

TM70Bi.v1.1.doc (10/03) 12

Solid green

Transmitter transmitting normally. OPERATION mode.

Green pulses.

Transmitter ready for start-up. STAND BY mode.

Red slow flashing

Battery level low

Red fast flashing

EEPROM module is not plugged in.

Red double flashing

Transmitter cannot start up because a motion

command is present.

Solid red

Transmitter failure

RECEIVER

In OPERATION mode the 5 LED’s must be lit as has been previously described in

section 4.3 Starting. If this is condition exists, press the transmitter motion buttons and

observe the response of the output relays. If the response is normal, the problem is not

related to the remote control equipment and the installation must be evaluated. If any

of the relays are not activated, the problem is associated with the remote control

equipment. If this happens, observe the status of the LED’s:

LED

LIT

OFF

SIGNAL

RF signal OK

RF signal detection in

SCANNING mode

The receiver is not

receiving RF signals

POWER

Power Supply OK

Power Supply not OK

HARDOK

Board OK

Slow: fault in the board

Fast: error in EEPROM

Fault in the board

ID Code OK (1)

ID not recognised

DATA

Is receiving the correct

data from a TM70 (1)

Signal received is not

correct

(1): DATA and ID LED’s show a weak flashing when data and the ID code are received

correctly but the Start command has not yet been received. Once Start button is

pushed ON the DATA and ID LED’s will show the standard strong flashing.

1 2 ... 8 9 10 11 12 13 14 15 16

Comentários a estes Manuais

Sem comentários

Cervis TM70 Manual de Instalação Página 13

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Cervis TM70