Cervis TM70 Manual de Instalação descarregar pdf (Página 8)

TM70Bi.v1.1.doc (10/03) 7

The STOP relays K15 and K16 are in series and must be connected to the main

contactor coil circuit.

The K2/START is activated once the start-up command is held down.

The K1/SEC relay is a security relay, which is activated when certain commands

predefined as “active” on configuration of the system, (i.e. commands which give rise to

movements), are activated.

Remember to connect the ground cable.

Only use fireproof cables for connections.

Select the appropriate voltage on the receiver, (230, 115 or 48 Vac)

4.3.- STARTING UP

Proceed with caution; the equipment may not be connected correctly

which may lead to unexpected movements upon start-up.

K16

K15

K12

K14

K13

K11

K10

SIGNAL

POWER

HA RDOK

DA TA

K14

K13

K12

STOP

K11

K10

N23 0/ AC

+/AC

N11 5/ AC

?/DC

N48 / AC

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

OPERATION & INSTALLATION 1
PUSHBUTTON TRANSMITTERS 1
I N DEX 2
TM70Bi.v1.1.doc (10/03) 2 3
TM70Bi.v1.1.doc (10/03) 3 4
TM70Bi.v1.1.doc (10/03) 4 5
TM70Bi.v1.1.doc (10/03) 5 6
TM70Bi.v1.1.doc (10/03) 6 7
TM70Bi.v1.1.doc (10/03) 7 8
TM70Bi.v1.1.doc (10/03) 8 9
TM70Bi.v1.1.doc (10/03) 9 10
TM70Bi.v1.1.doc (10/03) 10 11
TM70Bi.v1.1.doc (10/03) 11 12
TM70Bi.v1.1.doc (10/03) 12 13
TM70Bi.v1.1.doc (10/03) 13 14
TM70Bi.v1.1.doc (10/03) 14 15
TM70Bi.v1.1.doc (10/03) 15 16

Sem comentários

Cervis TM70 Manual de Instalação Página 8