Cervis TM70 Manual do Utilizador descarregar pdf (Página 8)

I K U S I

21/05/2008

RECEIVER LED STATUS

CHART 5

9 Check the Receiver Led Status as described below in order to fix the system. Once the system is fixed, go to . ( ).

START

CHART 1 (I)

LED LIT FLASHING OFF RECOMMENDED ACTION

POWER Power supply OK. ---- Power supply NOTOK. Verify power supply. If OK,

replace the receiver logic board

(LR71 or LR72) keeping the

EEPROM.

HARDOK Board OK. Slow: fault in the board. Fault in the board. Replace receiver logic board

(LR71 or LR72) keeping the

EEPROM.

Fast: error in EEPROM. Replace the EEPROM.

SIGNAL RF signal OK . RF signal detection in The receiver is not Go to .

SCANNING mode. receiving RF signal.

DATA ---- Is receiving the correct TM70 interference signal Go to .

data from a TM70. or signal not correct.

ID ---- ID code OK. ID code NOTOK. Go to .

NOTE: There are 2 extra LED’s in the LR72 card, CAN-RUN (green) and CAN-ERR (red). They control the situation of the CAN-BUS.

LED LIT FLASHING OFF RECOMMENDED ACTION

POWER Power supply OK. ---- Power supply NOTOK. Verify power supply. If OK,

replace the receiver logic board

(LR71 or LR72) keeping the

EEPROM.

HARDOK Board OK. Slow: fault in the board. Fault in the board. Replace receiver logic board

(LR71 or LR72) keeping the

EEPROM.

Fast: error in EEPROM. Replace the EEPROM.

SIGNAL RF signal OK . RF signal detection in The receiver is not Go to .

SCANNING mode. receiving RF signal.

DATA ---- Is receiving the correct TM70 interference signal Go to .

data from a TM70. or signal not correct.

ID ---- ID code OK. ID code NOTOK. Go to .

NOTE: There are 2 extra LED’s in the LR72 card, CAN-RUN (green) and CAN-ERR (red). They control the situation of the CAN-BUS.

CHART 8

CHART 9

CHART 10

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Sem comentários

Cervis TM70 Manual do Utilizador Página 8