Cervis TM70 Manual de Instalação descarregar pdf (Página 13)

Operation and Installation Manual

2013 Cervis, Inc.

3.0 CB70 Battery Charger and BT24IK Batteries

THE BATTERIES MUST BE INITIALLY CHARGED BEFORE USE.

Batteries must be charged for a full twelve (12) hours before

they can be installed in the transmitter. Using a battery before

initially charging will shorten its life span and can possibly

result in an immediate degradation of service.



Note: You must fully charge the batteries before installing and using in the

transmitter. It takes twelve (12)hours to initially charge or recharge an exhausted

battery. Once a battery is charged, do NOT charge it again until the transmitter

indicates a low charge. You will shorten the battery life by charging it before it is

exhausted. To guard against disruption of service, be sure to have one battery fully

charged or in the process of being fully charged while the other is in use at all times.

The CB70 battery charger, Figure 2, has two charging cradles and is capable of simultaneously

charging two BT24IK batteries. Nominal charging time for new or discharged batteries is a

minimum of 12 hours. Initial charging should be at least 12 hours, recommended that the

charger be left powered ON overnight.

Figure 2. CB70 Battery Charger



Note: The Charging LED lights when the battery is first seated in the cradle indicating

the battery is properly seated and is charging. The Charging LED goes out after 12

hours of charging.

LEDs lit while charging

BAT1 BAT2

Power LED lit

when powered by

the Power Supply

Charger Power Supply

BT24IK 4.8V

Batteries

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 102 103

Sem comentários

Cervis TM70 Manual de Instalação Página 13