Cervis TM70 Manual de Instalação descarregar pdf (Página 63)

Operation and Installation Manual

2013 Cervis, Inc.

17.2 Two Master Transmitter Systems

Figure 32.Two Master Transmitters System

In Two Master Transmitter Systems, each transmitter will have a 1/1+2/2 Selector Switch and

an R (release) Pushbutton.

When Tandem Operation Is Needed (Figure 32)

In the following example, Master II is going to become the tandem operator for Receiver 1 and

Receiver 2.

1. Transmitter Master 1 operator must simultaneously press the R (release) and START

buttons. This frees Receiver 1.

2. Transmitter Master 2 operator sets the selector switch to 1 & 2.

3. Transmitter Master 2 operator presses and holds the START button until the Green LED

switches ON. This commands Receiver 2 to release Receiver 2, and then new ID codes are

sent to both Receiver 1 and Receiver 2.

Both receivers 1 and 2 are then started, ready for tandem operation.

When Tandem Operation Is Finished

When tandem operation has finished, the Master Transmitter must select Switch Position 2

again (in our example above) and press the Start button. Receiver 1 is release again ready to be

used by the Slave Transmitter to reconnect. The Master Transmitter then only controls Receiver



Note: To reconnect Transmitter 1 to Receiver 1 in our example above, the operator must first

cycle the transmitter — power it OFF and then ON — and then press the START button while

the selector switch in set to 1.

ID1

ID2

ID1

ID2

ID1

ID2

MASTER I

MASTER II

RECEIVER 1

RECEIVER 2

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 102 103

Sem comentários

Cervis TM70 Manual de Instalação Página 63