Cervis TM70 Manual de Instalação descarregar pdf (Página 60)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

16.6.3 LA70M Installation and Connections

Make sure the machine is switched OFF and the work area is clear

during assembly.

Disconnect the power supply from the crane/machine. Check to

make sure power is OFF.

Be sure to connect the Earth Ground cable.

Use only those cables supplied by the manufacturer for connections

between the Master and Slave (or expansion) modules.

1. Select a suitable place to install the infrared transmitter. Make sure that it is away for

anything that could cause intense electrical disturbances. Make sure that there are no

obstructions to light transmission from the module.

2. Connect the unit to the proper power supply.

3. Jumper the Master/Slave block as MASTER.

4. Select the code that is programmed in the EEPROM of the transmitter.

5. Make sure to cap the last expansion module port with the supplied cap.



Note: The maximum number of Expansion Modules for each Master Module is two (2).

Figure 30. LA70M and LA70M Expansion Network

LA70M AC / LA70M DC

LA70M EX

ID=3 (*)

AC/DC Power Supply

LA70M EX

CAP

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 102 103

Sem comentários

Cervis TM70 Manual de Instalação Página 60