Cervis TM70 Manual de Instalação descarregar pdf (Página 40)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

Table 9. Receiver LED Maintenance and Troubleshooting

LED

Color

Status

Description

Suggestion

POWER GREEN

Switch ON if powered Power supply OK

HARDOK GREEN

Solid Green– OK Hardware OK

Blinking during start-up Hardware OK

Please wait to

finish the start-up

HARDOK RED

Solid Red – ERROR

- Watchdog activated

- Oscillator breakdown

- Wrong checksum

- Reset activated

Electronic board

breakdown

Replace board

Blinking fast – ERROR

- Wrong EEPROM

Checksum

- Data corrupted

- CAN Bus error

EEPROM problem

Reprogram

EEPROM

SIGNAL GREEN

OFF – no radio signal

detected (Squelch)

LED ON when the

transmitter switched

OFF indicates an

occupied radio channel.

LED ON and DATA

switched OFF indicates

radio channel occupied

by a non-Ikusi system.

Check transmitter

radio and battery

DATA GREEN

Blinking – Correct ID received

OFF and SIGNAL LED

ON indicates radio

breakdown.

Replace radios

ID GREEN

Blinking if correct ID received.

Switched OFF and

DATA LED ON: no valid

If the radio channel

is not busy: verify

transmitter’s

selected ID or

reset receiver ID.

SIGNAL, DATA, and ID

LED ON indicates valid

frames from the

transmitter. Correct link.

RELAY GREEN

STOP relay activated

ORDER GREEN

CAN-RUN

(Internal)

GREEN

Indicates system status when in CANopen machine state:

• Preoperational State – Blink every 200ms

• Permanent Operation State – Solid green

• Stop State – One blink per second

CAN-ERR

(Internal)

RED

Indicates error in the field-bus when switched on. Must be switched OFF in

normal conditions.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 102 103

Comentários a estes Manuais

Sem comentários

Cervis TM70 Manual de Instalação Página 40

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Cervis TM70