Cervis TM70 Manual de Instalação descarregar pdf (Página 80)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

23.4 A2ICAN Connections and Jumper Configurations

23.4.1 LR72 Connections

The expansion card connects to the LR72 board using two (2) connectors: one 2-pin connector

for the power supply (VI+ and GND), and a 5-pin connector for the CAN bus. See Table 28.

Table 30. A2ICAN Connections to LR72 Board (see Figure 48.)

2-Pin Connector

Name

Function

GND

Ground

+VI

DC power supply between 8 and 30V

5-Pin Connector

Name

Function

VCAN

Power Supply

CANH

CANH bus signal (CAN high)

GNDCAN

Ground (Shielding)

CANL

CANL bus signal (CAN low)

GNDCAN

CAN Ground

23.5 Outputs

Each Analog Output has two serial relays that switch the output signal in one of two ways: Direct

or Inverse. If none of the relays are activated, these outputs (Direct and Inverse) are

disconnected.

23.5.1 Output PWM1

Output1 is connected to the 4-pole terminal block shown in Figure 48.

Table 31. Output PWM1 Connections

5-Pin Connector

Name

Function

VPP1

Channel 1 power

GND1

Channel 1 ground

VO1

Channel 1 Direct Analog PWM output

VR1

Channel 1 Inverse Analog PWM output

23.5.2 Output PWM2

Output2 is connected to the 4-pole terminal block shown in Figure 48.

Table 32. Output PWM2 Connections

5-Pin Connector

Name

Function

VPP2

Channel 2 power

GND2

Channel 2 ground

VO2

Channel 2 Direct Analog PWM output

VR2

Channel 2 Inverse Analog PWM output

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 102 103

Comentários a estes Manuais

Sem comentários

Cervis TM70 Manual de Instalação Página 80

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Cervis TM70