Cervis TM70 Manual de Instalação descarregar pdf (Página 90)

TM70/3-10 & i-Kontrol Console RC System

U035.3-TM70_Console_Sys

25.2 Menu 3.1 Adjust



Note: It is important to remember to Confirm/Validate each setting adjustment for each

parameter in each semi-axis before going back or exiting the menu. If the desired setting is

not confirmed before leaving the currently displayed changed parameter, the desired setting

is lost; it will not be available to be saved to the EEPROM.

Once all desired parameter settings are made, you must use the 4. SAVE ALL menu to

record all changed settings to the EEPROM.

25.2.1 Parameter Response Type

The graph in Figure 56 shows the different response types that can be chosen for the parameter

action.

Figure 56. Parameter Configuration Options

In this menu, the user is asked to select the output response. Outputs associated with the

selected response type are displayed as follows:

X EXP_TYPE Y

Where:

X is the Number of the analog output

Y is the Output Number of the output

EXP_TYPE is the type of analog output (A1P4CAN, A2VCAN, or A2ICAN)

The user must select which output to tele-adjust. The chosen output should be flashing. If two

outputs display, use the UP/DOWN keys to select the desired output and confirm the selection

by pressing START. The selected output will briefly display.

Szero

Type

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 102 103

Sem comentários

Cervis TM70 Manual de Instalação Página 90