Cervis TM70 Manual do Utilizador descarregar pdf (Página 30)

Technical Assistance Services (01/08) 27

Consists of the governance of a single crane with two or more transmitters; the ID codes

will determine which transmitters can work with said crane.

The first transmitter to send the start order will be the first to take control of the crane, and

will not let any other transmitter have the control of the crane until said transmitter is turned off and

the programmed safety time has passed.

For safety, we can delay the change of one transmitter to another from the moment that

the STOP button is pushed, not allowing another transmitter to take control of the crane until the

programmed time has passed: 0,1 sec. to 25 seconds, by default 4 seconds.

We can use up to a maximum of 32 transmitters.

5.2.- OPERATION PITCH & CATCH

Consists of the governance of a single crane with two or more transmitters; the ID allow

any other transmitter the control of the same until said transmitter is turned off. If at the moment

2. One of the personalized transmitters

pushes start and takes charge of the

crane.

3. Only the transmitter that has taken the

crane will work. The receiver ignores the

rest of the transmitters.

5. The receiver will wait the programmed

safety time and once said time has

passed, will begin to scan again.

4. On finishing the work push the Stop

button so the receiver will be freed and

another transmitter can take it.

6. A different transmitter or the same one

pushes start and takes charge of the

receiver, repeating the cycle.

1. The receiver will begin to scan to

check if a transmitter of those that are

personalized is requesting work.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 48 49

Sem comentários

Cervis TM70 Manual do Utilizador Página 30