Cervis TM70 Manual do Utilizador descarregar pdf (Página 45)

Technical Assistance Services (01/08) 42

2. If the Power led lights up, check the Hard led, if the Hard led does not light up, substitute the

eeprom of the receiver with the eeprom of the transmitter, you do not forget to load it you have to

press the white button 4 seconds. If it lights up with the led of the transmitter, copy the eeprom of

the transmitter to the receiver and if it still does not light up with the eeprom of the transmitter,

substitute the LR70 card.

3. If the Power and Hard leds light up, with the button panel turned off, check if the

signal led lights up occasionally. This led lights up whenever it receives a radio signal. If it never

lights up check the state and the connection of the antenna and if it is not corrected, substitute the

LR70MR06. If it lights up very often, this may mean interferences; check whether there is any

button panel with the same frequency.

4. If we have made sure that the Power and Hard led light up and the Signal led lights up

occasionally. Turn on the button panel and keeping the start button pressed, check that the

signal led, data leds (correct signal) and ID (code OK) blink very rapidly, relay led is green and

order led turn on each time you press a maneuver. If they do not, substitute the LR70 and carry

out operation tests; if it continues to fail, replace the LR70 and substitute the transmitting logic

7.3- DIFFERENTS POWERS SUPPLY OF THE MR06

For 24v AC power, you must put a transformer 2x24/2,4VA (195009) and put or set bridge

the resistors R207 and R208 (115085).

2. With out battery, release the broken board and

replaced for a new one. These boards goes with 4

screws pozidriv or torx.

3. Introduces the EEPROM EP70 from the broken

board to the new one board.

4. Charge the board and press the button about 3

seconds to load the eeprom. The led from the hard will

start to blink during 15 seconds and it will stay on

waiting for work.

1. Unscrew the four screws to open the cabinet torx

T-20.

1 2 ... 40 41 42 43 44 45 46 47 48 49

Sem comentários

Cervis TM70 Manual do Utilizador Página 45