Cervis TM70 Manual do Utilizador descarregar pdf (Página 42)

Technical Assistance Services (01/08) 39

It is possible that for some reason, for example, the crushing of a transmitter, the eeprom of

the transmitter is destroyed and on replacing the unit crushed with a new transmitter we will also

need a new eeprom, with the data of the unit. This operation is called copying of eeprom and

consists of copying the data of the eeprom of the receiver on a virgin eeprom for the transmitter or

vice versa, as indicated on following page.

Copying of the eeprom can only be done by qualified personnel and it will only be done

when they are certain that the eeprom to be substituted is totally unusable and whenever an

eeprom is recorded, the old one must be eliminated, to prevent two units from having the same

eeprom and therefore, the same data.

6.3.- PROGRAMMING OF A RESERVE TRANSMITTER IKONTROL

This is the ideal solution recommended by the IKUSI technical assistance service to users

for quick repair. It involves having one or several reserve transmitters, depending on the

number of remote controls installed, so as to replace the broken transmitter quickly and

simply.

1. Without feed, remove the

EEPROM EP70 module from the

receiver.

2. Put the EEPROM EP70 module

removed from the receiver, into

the transmitter.

3. With battery, turn the key to the

contact position and push and

extract the stop button. The LED

will light up a moment in amber, will

blink green for 15 seconds and will

turn off.

4. Push the enter into copying of

eeprom mode button, square,

(the LED blinks red at the rhythm of

two on, one off) and then the start

button; the led will continue

blinking red at the rhythm of two

on, one off. Keep both pressed

about 5 seconds, until the led

begins to blink amber. When it

stops blinking, the led will turn

green.

7. Press the copying of eeprom

button, square, for about 5

seconds, until the led indicator

turns green, after having blinked

amber. On releasing the button the

led will turn off. The EP70 is now

programmed.

8. To work, turn the key to

contact position and push and

extract the stop button. The LED

indicator will light up a moment in

amber, will blink green for about 15

seconds and will turn off. Pushing

start the unit will begin to work.

6. Put the virgin EEPROM EP70

module into the transmitter.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 48 49

Comentários a estes Manuais

Sem comentários

Cervis TM70 Manual do Utilizador Página 42

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Cervis TM70